1. Prototype or validation status
This list covers the skills and tools needed for the current tested build. See Project status for the supported hardware revision.
2. Safety notice
- A soldering iron reaches temperatures that cause burns. Use a stand and work in a ventilated area.
- 3D printers have hot nozzles and beds. Follow your printer’s instructions.
- Lithium batteries can catch fire if shorted, punctured or overheated. Never short the battery leads.
- Static electricity can damage the boards. Use an antistatic mat or wrist strap.
3. Required parts and tools
Skills:
- Through-hole soldering. Preparing the RTC module also requires removing a small surface-mount resistor.
- Reading a schematic and checking continuity with a multimeter.
- Preparing and printing 3D models.
- Crimping or assembling small connectors to make the custom I²C and audio cables.
Tools:
3D printing
- 3D printer.
- Craft knife or a similar tool for removing supports from the enclosure.
- Drill or small file to enlarge enclosure openings, if needed.
Soldering
- Temperature-controlled soldering iron, solder and flux. Leaded solder melts at a lower temperature and can be easier for beginners to use, but it contains lead and must be handled with appropriate precautions. Wash your hands after use and keep food and drinks away from the work area.
- Flush cutters, wire strippers and tweezers.
- A PCB holder is optional, but it makes work on the I/O board much easier.
- A fume extractor is optional but highly recommended.
Making custom cables
- An open-barrel contact crimping tool. The IWISS IWS-3220M is suitable for the small contacts used in this build.
Assembly
- A Phillips screwdriver with a PH2 bit. The screwdriver shaft must be narrow enough to clear the display glass while securing the Elecrow board because there is very little clearance between the screw holes and the glass.
Troubleshooting
- Multimeter with continuity test.
Firmware update
- A computer with Chrome or Edge for installing firmware.
4. Procedure
Read every build page before you start, and gather all parts and tools.
5. Expected result
You have the skills, tools and workspace needed for the build.
6. Inspection or test
Check your multimeter’s continuity beeper and your soldering iron temperature before starting.
7. Failure conditions
If you are not confident with soldering and electrical testing, practise on a simple project first, or build alongside an experienced builder, for example at a club build night.