First firmware installation

1. Prototype or validation status

A new display board requires a full installation, including the voice image and internal content. Use the recovery installer for this first installation; it also erases the factory-installed contents on the board.

2. Safety notice

Use a data-capable USB cable connected directly to the computer. Do not disconnect during installation.

3. Required parts and tools

  • The assembled Morse Scout, or the bare display board.
  • A data-capable USB cable.
  • A computer with Chrome or Edge.

4. Procedure for first flash

  1. Connect the USB cable to the USB TO UART port on the display board. The board has two USB ports; use the one closest to the power switch. The photograph below shows the correct port.
Photograph showing the USB TO UART port with a cable connected
  1. Open the Firmware Recovery page in Chrome or Edge.
  2. Continue with the instructions on the Firmware Recovery page.
  3. Select the install button and choose the board’s serial port.
  4. For the first installation, select Erase device. For subsequent installations, use the standard firmware update procedure instead.
  5. Wait for completion, then press RESET or disconnect and reconnect power.

The recovery installer writes the Morse Scout application, internal content and voice image. Later updates use the normal firmware update procedure, which preserves the internal content and voice image.

5. Expected result

The board restarts and shows the Morse Scout startup animation and main menu.

6. Inspection or test

  • The startup screen shows the expected firmware version.
  • Receive → Words shows the included word lists in Source List.
  • Speech works in Receive Words with Say After on.

7. Failure conditions

  • The installer cannot connect: try another cable, close other programs using the port, and repeat the BOOT/RESET sequence.
  • The board starts but has no word lists or speech: the full installation did not complete. Run it again.
  • Normally, the board does not need to be put into download mode, but if the Firmware recovery fails, try the following sequence: 1. Hold BOOT. 2. Press and release RESET. 3. Release BOOT. 4. Update firmware

8. Next step

Bring-up tests