Wi-Fi coprocessor firmware

Morse Scout has two processors: the ESP32-P4 runs the application and the ESP32-C6 provides Wi-Fi. Each Morse Scout release includes its required radio firmware. No separate download or microSD card is needed.

Start the update

After installing Morse Scout firmware with the WebFlasher, keep USB power connected. Follow the update prompt on the device, or open Settings → Diagnostics and select the radio update button when available.

The screen shows the installed and required versions. Not recognized means Morse Scout could not verify the required firmware; it does not prove that factory firmware is installed.

Radio update offered
  1. Read the message and select Update.
  2. Connect USB power, then confirm that it is connected. Morse Scout relies on your confirmation; it cannot reliably detect USB power automatically.
  3. Keep USB connected throughout installation and verification.
USB power confirmation

Installation and verification

The progress bar shows installation progress. Wi-Fi is unavailable during installation. Do not switch off the device or disconnect USB power.

Installation progress

Morse Scout restarts and checks the firmware reported by the radio. Wait for the final result; the end of the progress bar alone does not confirm success.

Radio firmware verification

On success, select Continue. The result remains visible until you do. You can then disconnect USB power and check your Wi-Fi connection.

Successful update awaiting Continue

Cancel or recover

You may cancel before installation begins and return later through Settings → Diagnostics. Personal Wi-Fi may still work with unverified radio firmware, but WPA-Enterprise is unavailable until the required radio firmware is verified.

If installation fails, keep USB connected and follow the displayed recovery instructions. Use Retry when offered. Do not assume the previous radio firmware remains usable after an interrupted write.

Update failure and recovery actions

If updating is unavailable, read the explanation on screen. Record that message and the firmware versions when requesting support.

Update unavailable